| Author |
 Topic  |
|
|
ambersdad
Snake Mite
United Kingdom
4 Posts |
 Posted - 31/01/2012 : 23:35:51
|
hi all
i have a heat mat on a mat stat and a sun glo lamp, the guy at the shop said to have the lamp on during the day and the mat at night, is this right? the temp is at about 80f with the lamp on. does it need to be on all day? or just a few hours? if so how many? i am getting some led lights for viewing just concerned the sun glo maybe to much for the snake.
any comments greatly recived |
|
|
Elicia
Hatchling
222 Posts |
Posted - 31/01/2012 : 23:40:55
|
Hi
Why the lamp AND a heat mat? Most people only have the heat mat. I would do away with heat lamp and have just the mat. And then just pop the LED lights on for viewing (I have mine on at night when wathing telly)x
x |
 
Normal Corn-Percy
Speckled King-Bumblebee |
 |
|
|
ambersdad
Snake Mite
United Kingdom
4 Posts |
Posted - 31/01/2012 : 23:45:52
|
its what we got told in the shop.
if i just have the mat on what temp should i set the stat to and will this be ok all the time? |
|
|
|
NiallP
Snake Mite
United Kingdom
48 Posts |
Posted - 01/02/2012 : 00:14:12
|
| If you set it to about 29oC it should be fine, but see how your snake is. If your snake starts to spend all the time in the cool end, then turn the stat down a degree. And yes, this will be ok all the time |
|
|
|
Auld Baldy
Ikea's Pimp
United Kingdom
1619 Posts |
Posted - 01/02/2012 : 00:17:16
|
Ditch the sun-glo and fit the LED lights. There is a good set available from IKEA. I have 3 set ups with them.
http://www.ikea.com/gb/en/catalog/products/90192071/
The Stat should be set to a range between 21C to 30C (max). Use a digital thermometer attached to the stat sensor probe and laid on top & middle of the heat mat panel to monitor the temps. Weigh it down with a hide or other furniture to keep it from being dislodged. You can leave it switched on permanently.
Have a look at the Care Sheet for general information and also the 'sticky' posts in the relevant forums. Anything else, just ask.  |
1.0.0: Miami Normal: Taggart
0.0.1: Carolina Normal: Wee Woody
0.0.1: Grey Rat Snake: Mirkey
0.0.1: Amel Corn: Blaze
1.0.0: Carpet Python: Vambo
0.0.1: MBK: Fester
0.0.1: Florida King Snake : Rattler (Rattle & Hum)
0.0.1. California King Snake: El Diablo Diego
0.2.0 Tarantulas : Ermintrude & Euphemia. |
|
|
|
Okeetee Mick
Fully Grown Corn
United Kingdom
2308 Posts |
Posted - 01/02/2012 : 10:45:20
|
This thread might help
http://www.thecornsnake.co.uk/forum/topic.asp?TOPIC_ID=20978&SearchTerms=Heat,lamps |
0.1.0 Okeetee (Sookie) 0.1.0 Powder (Luna) 0.1.0 Bloodred (Arlene) 0.1.0 Caramel Stripe (Tara)
0.1.0 Ghost (Crystal) 0.1.0 Caramel (Jessica) 0.1.0 Lavender Stripe (Portia) 1.0.0 Platinum (Godric)
0.1.0 Thayers King (Lettie Mae) 0.1.0 Albino Blairs King (Lorena) 0.1.0 Russian Ratsnakes (Pam)
0.1.0 Korean Ratsnake (Katerina) 1.0.0 Russian Ratsnake (Lafayette)
 |
|
|
|
ambersdad
Snake Mite
United Kingdom
4 Posts |
Posted - 01/02/2012 : 22:12:11
|
| thanks for your help |
|
|
|
CentricMalteser85
Banned Again
United Kingdom
131 Posts |
Posted - 01/02/2012 : 22:34:55
|
my set up is straight forward
heat mat covers one third of floor space, put all the way to left or right side, thin layer of substrate on it (i use it sparingly), thermostat probe and digital thermometre probe tied together in the middle hides on top and then nice thick and deep aspen on the cool side
for lighting i use GU10 led bulbs, and others use led strips as these giver pretty much almost no heat
you can even by day/night thermostats for heat mats to allow for a night time drop. Saves a lot on electricity too. |
|
|
| |
Topic |
|
heating and light
